| dc.description.abstract | Millimeter-wave (mmWave) is one of the key technologies that enables the next wireless
generation. mmWave offers a much higher bandwidth than sub-6GHz communications
which allows multi-gigabit-per-second rates. This also alleviates the scarcity of spectrum
at lower frequencies, where most devices connect through sub-6GHz bands. However new
techniques are necessary to overcome the challenges associated with such high frequencies.
Most of these challenges come from the high spatial attenuation at the mmWave band,
which requires new paradigms that differ from sub-6GHz communications. Most notably
mmWave telecommunications are characterized by the need to be directional in order to
extend the operational range. This is achieved by using electronically steerable antenna
arrays, that focus the energy towards the desired direction by combining each antenna
element constructively or destructively. Additionally, most of the energy comes from
the Line Of Sight (LOS) component which gives mmWave a quasi-optical behaviour
where signals can reflect off walls and still be used for communication. Some other
challenges that directional communications bring are mobility tracking, blockages and
misalignments due to device rotation. The IEEE 802.11ad amendment introduced wireless
telecommunications in the unlicensed 60 GHz band. It is the first standard to address
the limitations of mmWave. It does so by introducing new mechanisms at the Medium
Access Control (MAC) and Physical (PHY) layers. It introduces multi-band operation,
relay operation mode, hybrid channel access scheme, beam tracking and beam forming
among others.
In this thesis we present a series of works that aim to improve mmWave
telecommunications. First we give an overview of the intrinsic challenges of mmWave
telecommunications, by explaining the modifications to the MAC and PHY layers. This
sets the base for the rest of the thesis. Then do a comprehensive study on how mmWave
behaves with existing technologies, namely TCP. TCP is unable to distinguish losses
caused by congestion or by transmission errors caused by channel degradation. Since
mmWave is affected by blockages more than sub-6GHz technologies, we propose a set
of parameters that improve the channel quality even for mobile scenarios. The next job
focuses on reducing the initial access overhead of mmWave by using sub-6GHz information
to steer towards the desired direction. We start this work by doing a comprehensive High
Frequency (HF) and Low Frequency (LF) correlation, analyzing the similarity of the
existing paths between the two selected frequencies. Then we propose a beam steering
algorithm that reduces the overhead to one third of the original time. Once we have
studied how to reduce the initial access overhead, we propose a mechanism to reduce
the beam tracking overhead. For this we propose an open platform based on a Field
Programmable Gate Arrays (FPGA) where we implement an algorithm that completely
removes the need to train on the Station (STA) side. This is achieved by changing
beam patterns on the STA side while the Access Point (AP) is sending the preamble.
We can change up to 10 beam patterns without losing connection and we reduce the
overhead by a factor of 8.8 with respect to the IEEE 802.11ad standard. Finally we
present a dual band location system based on Commercial-Off-The-Shelf (COTS) devices.
Locating the STA can improve the quality of the channel significantly, since the AP
can predict and react to possible blockages. First we reverse engineer existing 60 GHz
enabled COTS devices to extract Channel State Information (CSI) and Fine Timing
Measurements (FTM) measurements, from which we can estimate angle and distance.
Then we develop an algorithm that is able to choose between HF and LF in order to
improve the overall accuracy of the system. We achieve less than 17 cm of median error
in indoor environments, even when some areas are Non Line Of Sight (NLOS). | es |
